filename: tfs 92d.doc version 1.3 11.04.2006 vi telefilter filter specification tfs 92d 1/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. measurement condition ambient temperature: 23 c input power level: 0 dbm terminating impedance: * input: 1260 ? || -2,5 pf output: 1260 ? || -2,5 pf characteristics remark: the nominal frequency f n is fixed at 92,025 mhz. the insertion loss a e is defined as loss value determined at f n. reference level for the relative attenuation a rel of the tfs 92d is the insertion loss a e . all specified data are met within the operating temperature range. d a t a typ. value tolerance / limit insertion loss a e 2,8 db max. 4,0 db (reference level) nominal frequency f n - 92,025 mhz passband pb - f n 15 khz pass band ripple 0,5 db max. 1,0 db bandwidth bw 3 db 51 khz min. 30 khz relative attenuation a rel f n ? f n 15 khz 0,5 db max. 1,0 db f n - 1,0 mhz ? f n - 910 khz 68 db min. 60 db f n - 910 khz ? f n - 900 khz 72 db min. 70 db f n - 900 khz ? f n - 300 khz 62 db min. 60 db f n - 300 khz ? f n - 120 khz 46 db min. 35 db f n + 200 khz ? f n + 500 khz 42 db min. 25 db f n + 500 khz ? f n + 1,0 mhz 58 db min. 40 db group delay ripple within pb 3,8 s max. 4 s input power level max. 10 dbm operating temperature range otr - - 20 c ... + 70c storage temperature range - - 40 c ... + 85c frequency inversion temperature 28 c temperature coefficient of frequency tc f ** -0.04 ppm/k 2 *) the terminating impedances depend on paras itics and q-values of matching element s and the board used, and are to be understo od as reference values only. should there be additional ques tions do not hesitate to ask for an applic ation note or contac t our design team. **) ? f c (hz) = tc f (ppm/k 2 ) x (t - t o ) 2 x f to (mhz). generated: checked / approved:
filename: tfs 92d.doc version 1.3 11.04.2006 vi telefilter filter specification tfs 92d 2/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. filter characteristic 91.1 91.28 91.46 91.64 91.82 92 92.18 92.36 92.54 92.72 92.9 -100 -90 -80 -70 -60 -50 -40 -30 -20 -10 0 frequency in mhz magnitude in db -15 -10 -5 0 magnitude in db 91.98 92 92.02 92.04 92.06 10 12 14 16 18 20 frequency in mhz delay in s construction and pin connection (all dimensions in mm) 13,6max. 6,8max. 1 2,0max. 8 9 10 1,5 2,54 0,15 2,54 0,15 0,8 0,1 1 2 3 4 5 6 7 11 12 date code 50 ? test circuit tfs 92d u15 1 ground 2 ground 3 ground 4 ground 5 output 6 output rf return 7 ground 8 ground 9 ground 10 ground 11 input 12 input rf return date code: year + week u 2006 v 2007 w 2008 ... c1 l1 saw l 2 c2 11 5 1, 2, 3, 4, 7, 8, 9, 10 6 12
filename: tfs 92d.doc version 1.3 11.04.2006 vi telefilter filter specification tfs 92d 3/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. stability characteristics, reliability after the following tests the filter shall meet the whole specification: 1. shock: 500g, 1 ms, half sine wave, 3 shocks each plane; din iec 68 t2 - 27 2. vibration: 10 hz to 500 hz, 0,35 mm or 5 g respecti vely, 1 octave per min, 10 cycles per plan, 3 plans; din iec 68 t2 - 6 3. change of temperature: -55 c to 125c / 30 min. each / 10 cycles din iec 68 part 2 ? 14 test n 4. resistance to solder heat (reflow): reflow possible: twice max.; for temperature conditions refer to the attac hed "air reflow temperature conditions" on page 4; this filter is rohs compliant (2002/95/eg, 2005/618/eg) packing tape & reel: iec 286 ? 3, with exception of value for n and minimum bending radius; tape type ii, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: 1700 reel of empty components at start: min. 300 mm reel of empty components at start including leader: min. 500 mm trailer: min. 300 mm g do w ct f e g d1 p2 p1 po bo ao pull off direction pin marker typ date code ko t a c n w 1 w 2 the minimum bending radius is 45 mm. tape (all dimensions in mm) w : 24,00 +0,30/-0,10 po : 4,00 0,1 do : 1,50 +0,1/-0 e : 1,75 0,10 f : 11,50 0,10 g(min) : 0,60 p2 : 2,00 0,1 p1 : 12,00 0,1 d1(min) : 1,50 a o : 7,10 0,10 bo : 13,90 0,10 ct : 21,5 0,1 reel (all dimensions in mm) a : 330 w1 : 24,4 +2/-0 w2(max) : 30,4 n(min) : 60 c : 13,0 +0,5/-0,2
filename: tfs 92d.doc version 1.3 11.04.2006 vi telefilter filter specification tfs 92d 4/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. air reflow temperature conditions conditions exposure average ramp-up rate (30c to 217c) less than 3c/second > 100c between 300 and 600 seconds > 150c between 240 and 500 seconds > 217c between 30 and 150 seconds peak temperature max. 260c time within 5c of actual peak temperature between 10 and 30 seconds cool-down rate (peak to 50c) less than 6c/second time from 30c to peak temperature no greater than 300 seconds temperature / c time / s max. 260c 217c 10 ... 30 s 30 ... 150 s max. 300 s chip-mount air reflow profile
filename: tfs 92d.doc version 1.3 11.04.2006 vi telefilter filter specification tfs 92d 5/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. history version reason of changes name date 1.0 generation of development specification adh 15.02.2006 1.1 change passband and relative attenuation from f c to f n strehl 17.02.2006 change characteristics 1.2 change operating temperature range alawneh 28.02.2006 1.3 generation of filter specification martens 11.04.2006 add filter characteristic add typical values
|
